Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 153 / 322

Maintenance 5 - 17
Standard Turntable Power Washer v. 4.0 The MART Corporation
2.4. Turntable and Drive Assembly
This section describes maintenance procedures for the following:
·
Turntable bearings (grease; Lubriplate 1444)
·
Turntable drive bearings (grease; Mobilith AW2)
· Slip clutch/torque limiter (inspect)
· Door bearings (grease; Mobilith AW2)
2.4.1. Turntable Bearings (Grease)
Grease the upper and lower turntable bearings with Lubriplate 1444. Refer to Fig. 5-3.
NOTE : It is imperative that the turntable bearings be greased
every 8 hours of operation! (except Cyclone 30’s and Tornado 40’s
Pump in enough grease at each lubrication interval to completely fill the bearing. The
quantity required will depend on the bearing size and other wash parameters which you
set. As a rule of thumb when using a hand grease gun, pump until the grease gun feels
“stiff” and then add an additional 2 or 3 pumps/squirts or until grease is visible at the
seals.
Cyclone 30’s and Tornado 40’s Turntable roller bearings only.
Cyclone 30’s and Tornado 40’s have extended life bearings that require
lubrication every 1100 hours of operation.
To lubricate the turntable roller bearings proceed as follows.
Remove the turntable. Remove the rubber seal from the top of the turntable spindle
head. Locate zerk fitting and re-lubricate bearing with Lubriplate 1444 untill grease is
visible around upper bearing nut. Replace seal and re-install turntable.
2.4.2. Turntable Drive Bearings (Grease)
Grease the turntable drive bearings with Mobilith AW2. Refer to Fig. 5-3.
2.4.3. Slip Clutch/Torque Limiter (Inspect)
The slip clutch is factory pre-set to 45 foot-pounds (6.2 kg-m), which is 5 foot-pounds (.7
kg-m) below the allowable motor torque. Slight slippage during washing is common and
normal.
Inspect the slip clutch/torque limiter during operation of the washer. Under normal
operation you may can see some slippage -- the sprocket jack shaft starts and stops
while the motor shaft turns constantly. However, if the clutch slips constantly and
nothing is jamming the turntable, you need to adjust the clutch.