Mart Cyclone 30 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 61 / 322

Installation 2 - 13
Standard Turntable Power Washer v. 4.0 The MART Corporation
5. You may wish to grout the washer's base angle. If so, keep the following in
mind:
Grouting is designed to fill the area between the base angle and the
concrete -- permanently and completely -- and securely bond the base angle
to the concrete. However, grout is not "glue," nor does it do the work of the
anchor bolts. It is meant to provide vertical support and absorb operating
forces. Additionally, grout seals the base angle to the floor, so that water
and moisture cannot get under the washer and cause corrosion.
When placing grout, follow the manufacturer's detailed instructions to the
letter!
This will help prevent voids and other grout-repair problems later.
In general, use only non-shrink grout . The distributor should be able to tell
you whether the grout has been tested for shrinkage, before and after
hardening. And remember that most epoxy grouts require bone-dry
concrete.
For example, for concrete flooring, MART recommends an epoxy grout. To
test for dryness of concrete, tape a rubber mat or plastic sheet to the
concrete; check for condensation after 24 hours. Don't apply the epoxy if
there is any moisture.
Your distributor should give you the manufacturer's detailed instructions for:
·
Preparing the base angle
·
Equipment needed
·
Mixing the grout
·
Application