Basic Operations
3 - 3
Standard Turntable Power Washer v. 4.0
The MART Corporation
1. Control Panel
The following figure shows the standard control panel, located on the outside of the
washer cabinet to the left of the door. The operator uses these controls in day-to-day
cleaning-cycle operations:
Hour Meter
Monitor the total number of hours of washer cycle
time for scheduled maintenance procedures, from
start
to the
end
of cycle.
Rinse off/auto
set the rinse switch to
AUTO
to enable the rinse
cycle; OFF bypasses the rinse cycle.
7-Day Dual-Circuit
Clock
Program heat-up days and start/stop times for heat
and water-fill; program circuit #2 to control the
"auto" runtime for the optional Clean Machine or Oil
Skimmer.
Wash Cycle Timer
Set 0-30 minute wash cycle
7 Day Clock
Select
BYPASS
to override the 7-day clock. Select
ON
to enable the 7-day clock control.
Turntable Jog
Press the
TURNTABLE JOG
button to rotate the
turntable for easier loading/unloading.
Start (Run Light)
Press the
START
button all the way to begin the
wash cycle. The green run light illuminates
indicating cycle running.
Note
…The start circuit is interlocked with the door
closed limit switch. The opening and closing of the
washer door resets the start circuit.
Stop/
Reset
Press the
STOP
button to stop washer operations
(heat source and water-fill functions are not
affected). The green “Run Light” extinguishes
indicating cycle terminated.
NOTE:
If you have purchased any options, such as the Clean
Machine, Oil Skimmer, or Conductivity Controller, their operator
controls will appear on the control panel, if applicable. Refer to
chapter
"Options"
for more information.
NOTE:
If you specified any custom features, your control panel
may differ slightly from the standard panel. For example, your
wash timer may be located inside the electrical control panel. If
you requested a
water fault indicator
, it illuminates only if the water
level falls below operational requirements.
For more information on installing, operating, and maintaining options, refer to chapter
"Options."
Содержание Cyclone 30 Series
