LS ELECTRIC LSLV-H100 Series, Руководство пользователя

Страница: 255 / 618

242
Learning Advanced Features
Group Code Name LCD Display Parameter Setting Setting Range Unit
IN
65
–
71
Px terminal
configuration Px Define
(Px: P1
–P7)
28 2nd Motor 0-55 -
2
nd
Motor Operation Setting Details
Code Description
IN-65
–71 Px
Define
Set one of the multi-function input terminals (P1
–P5) to 26 (2nd Motor) to
display the M2 (2nd motor group) group. An input signal to a multi-function
terminal set to 2nd motor will operate the motor according to the code
settings listed below. However, if the inverter is in operation, input signals
to the multi-function terminals will not read as a 2nd motor parameter.
PRT-50 (Stall Prevent) must be set first, before M2-28 (M2-Stall Lev)
settings can be used. Also, PRT-40 (ETH Trip Sel) must be set first, before
M2-29 (M2-ETH 1 min) and M2-30 (M2-ETH Cont) settings.
Parameter Setting at Multi-function Terminal Input on a 2nd Motor
Code Description Code Description
M2-04 Acc Time Acceleration time M2-15 M2-Efficiency Motor efficiency
M2-05 M2-Dec Time Deceleration time M2-17 M2-Rs Stator resistance
M2-06 M2-Capacity Motor capacity M2-18 M2-Lsigma Leakage inductance
M2-07 M2-Base Freq
Motor base
frequency
M2-25 M2-V/F Patt V/F pattern
M2-08 M2-Ctrl Mode Control mode M2-26 M2-Fwd Boost Forward torque boost
M2-10 M2-Pole Num Pole number M2-27 M2-Rev Boost Reverse torque boost
M2-11 M2-Rate Slip Rated slip M2-28 M2-Stall Lev Stall prevention level
M2-12 M2-Rated Curr Rated current M2-29 M2-ETH 1 min
Motor heat protection
1 min rating
M2-13 M2-Noload
Curr
No-load current M2-30 M2-ETH Cont
Motor heat protection
continuous rating
M2-14 M2-Rated Volt Motor rated voltage