LiteOn EVO 6800 Series, Руководство пользователя

Страница: 38 / 261

38
shipped from the factory with a short-circuit jumper. Remove the jumper before
connecting a DC reactor.
+1 +2
(DC+)
DC Reactor (option)

If the drive is used in a high-frequency or heavy duty application which requires frequent
braking or shorter deceleration time, install an optional braking resistor to increase the
braking torque.
B1 B2
Braking Resistor (option)

Please refer to the wiring diagram when installing braking options.
4.2.2.4 Ground Terminal

Use grounding cables of dimensions regulated by electrical equipment standard. Shrink
wiring distance to prevent leakage current resulting unstable electrical potential at the
terminal distant from grounding terminal.

Do not use share the same grounding cable with welding machines or any device
requiring large current. Failure to comply could cause drive or equipment malfunction.

Do not wind the grounding cable when multiple drives are installed. Failure to comply
could cause drive or equipment malfunction.

Ensure the neutral of the input side and drive terminal " “ are grounded
according to the local electrician regulations. 3WYE (e.g. TN and TT) system are
suggested for the drive primary side.
4.2.2.5 Jumper：

EVO8000 complies with the European LVD standard EN 61800-5-1 (2007) reducing the
current leakage to below 10mA DC under testing condition regulated by IEC 60990
(1999).

Follow the instructions below to remove the jumper if an even lower current leakage to a