Copyright © Somfy SAS 8/2019 P-0038
Sonesse ULTRA 30 Wirefree (Li-Ion) RTS
Quick Programming Guide
NOTE:
Steps 1-6 must be completed to ensure proper shade programming and functionality. Motor will exit programming mode after 2 minutes of inactivity.
While in
programming mode
, the shade only operates when the UP or DOWN buttons are continuosly pressed. Releasing the buttons stops the shade.
INITIAL PROGRAMMING AND LIMIT SETTING
Step 2:
Check the direction of operation.
Press the
DOWN
button and confirm the
shade lowers.
Step 5:
PRESS &
HOLD
the
MY/STOP
button until the shade
jogs to confirm both
limit settings.
Step 3:
Bring the shade to your desired
upper limit.
PRESS & HOLD
both the
MY/
STOP and DOWN
buttons until the shade
begins to move down, then release. Stop the
shade at the desired lower limit, adjust by
pressing the
UP
or
DOWN
buttons.
Step 6:
To finalize
BRIEFLY PRESS
the
PROGRAMMING BUTTON
on the back
of the control. The shade will jog and will
now operate in
user mode
. Brief press
of the UP or DOWN button will send the
shade to the respective limit.
Step 1:
To initiate programming
PRESS
& HOLD
both the
UP and DOWN
buttons
at the same time until the shade jogs.
Step 4:
PRESS & HOLD
the
UP
and MY/STOP
buttons until the
shade begins to move up.
The shade will stop at the original
upper limit. Adjust if necessary.
Programming
Button
BEFORE YOU BEGIN: Check if you have a paired transmitter with the following directions:
1)
BRIEFLY PRESS
the
PROGRAMMING BUTTON on the motor
or plug in the charger.
The motor will jog once.
(A jog is a brief up and down motion).
2) If the transmitter was supplied, press a directional button (UP or DOWN) and see if the shade operates. If a multi-channel
transmitter was supplied, try on each channel.
a) If the shade operates - the shade is already programmed.
b) If the shade does not operate - choose the transmitter channel on which you would like to control the shade.
PRESS & HOLD
the
PROGRAMMING BUTTON on the motor
until it jogs once. Then
BRIEFLY PRESS
the
PROGRAMMING BUTTON on the transmitter.
The shade will jog once. The shade is now programmed.
If the shade raises instead of closing, change the direction -
PRESS
& HOLD
the
MY/STOP
button until the shade jogs.
Confirm correct direction of operation before proceeding.
ADJUSTING THE LIMITS IN USER MODE
Adjusting the
lower limit:
Adjusting the
upper limit:
Step 4:
PRESS & HOLD
the
MY/STOP
button until the
shade jogs, then release.
Check the new limit.
Step 3:
Adjust to a new
limit position using the
UP
or
DOWN
buttons.
Step 2:
PRESS & HOLD
both
UP and DOWN
buttons
simultaneously until the shade
jogs, then release.
Step 1:
Move the shade to
the current limit position you
wish to adjust and let it stop.
OR
OR
Programming
Button