135
29
O
O
O
30
O
O
O
31
O
O
O
32
O
O
O
33
O
O
O
34
O
O
O
35
O
O
O
36
O
O
O
37
O
O
O
38
O
O
O
<1> Determine the terminal status to detect the fault. (Normal Open: detection when terminal closed, normal
closed: detection when terminal open)
<2> Determine the detection should be enabled only during run or always detected.
39: Fault Reset
When a fault is detected, close the assigned terminal output, shut off the drive output and stop
the motor. Most of the faults cause the motor to coast, but stopping method can be set for
some faults (e.g. P1-03 Motor Overheat Fault Operation Selection). To restart the drive, either
remove the Run command, press the RESET key (
) on the keypad, or set 39 (Fault Reset) to
any terminal input in E1-00 to E1-07 and close the terminal input.
Note: A fault reset signal will be ignored during run. Remove the Run command to perform fault reset.
40 : oH2 (AC drive Overheat Alarm)
When the input terminal is closed, oH2 alarm is triggered (the drive continue operation).
41 : Multi-Function Analog Input Selection( Terminal A1 and A2)
Enabled or disabled the multi-function analog input. When the assigned multi-function
terminal input is open, the drive will ignore the analog input set to E3-12. To enable the analog
input set to E3-12, close the input terminal.
42~44: Retain
45 : Communication Mode
Set this when using communications. The assigned terminal input can receive signals from
Modbus or optional communication card.
46 : PID Disable
Even if PID control is enabled by b5-00 ( PID Control Setting), closing the assigned input
Содержание EVO 6800 Series
