8400 motec | Software Manual
Introduction: Parameterising the controller
General notes on parameters
16
L
Firmware
≤
02.00 - DMS 2.1 EN - 03/2011
2.1
General notes on parameters
All parameters for controller parameterising or monitoring are saved as so-called "codes".
The codes are numbered and indicated by the prefix "C" before the code, e.g. "C00002".
In addition, every code has a name and specific attributes:
– Access type (read, write)
– Data type
– Limit values
– Lenze setting (factory-set scaling)
For the sake of clarity, some codes contain "subcodes" for saving parameters. This
Manual uses a slash "/" as a separator between code and subcode, e.g. C00115/1".
According to their functionality, the parameters are divided into three groups:
Tip!
The terms "code" and "subcode" generally correspond to the terms "index" and
"subindex" and "parameter" and "subparameter".
Parameter group
Examples
Setting parameters
Parameters for specifying setpoints and for setting device /
monitoring functions.
: Selection of control mode
: Acceleration time - main setpoint
: Fixed setpoints
Configuration parameters
Parameters for configuring signal connections within the
device, e.g. assignment of the digital input terminals to the
control inputs of the application.
: System connection list: 16-bit
: System connection list: Bool
: LA_NCtrl: Analog connection list
: LA_NCtrl: Digital connection list
Diagnostic/Display parameters
Parameters for displaying device-internal process factors,
current actual values, and status messages, e.g. for
diagnostic purposes. These are read-only parameters.
: Motor voltage
: Device state
: Status word
: Error information
Содержание 8400 motec Series
Страница 375: ...L 375 ...