LAWO mc256 MKII, Техническое руководство

Страница: 212 / 372

mc²56 MKII Technical Manual V5.10.2/1 212
Chapter 3: AdminHD
Core Configuration: Parameters
Signal In/Out -> DSP
These parameters adjust the I/O DSP and Silence Detect alarms. Note that not all cards support these
parameters.
Signal In: I/O DSP
Gain Compensation Appears for inputs which support IP-SHARE . Tick the box to enable Gain
Compensation .
Note that if Gain Compensation is enabled, then you cannot enable I/O DSP (as it is
this which handles the gain compensation).
I/O-DSP Tick this box to enable the I/O DSP . Once enabled, the following parameters become
active:
Offset (dB)
Digital gain (dB)
Enter an offset and/or digital gain value in dB. The resultant gain ( Offset + Digital
gain ) is applied to the signal within the I/O card, and therefore affects all destinations.
The two separate parameters ( Offset and Digital gain ) allow you to apply a
‘permanent’ and a ‘temporary’ gain change. For example, to compensate for a low level
line input, use the
Offset parameter to apply a ‘permanent’ gain change. In addition, for
today’s production you can also need to compensate for a badly recorded signal; for
this ‘temporary’ adjustment, use the
Digital gain . At the end of the production, you
can easily reset the Digital gain to 0 dB while keeping the Offset gain intact.