LAWO mc256 MKII, Техническое руководство

Страница: 165 / 372

mc²56 MKII Technical Manual V5.10.2/1 165
Chapter 3: AdminHD
Core Configuration: Editing Parameters
Mapping Tables
Lawo’s Remote MNOPL protocol is a freely available Ethernet (TCP/IP) protocol providing control of virtually any
system parameter from an external device.
A typical application is to provide third-party matrix control so that crosspoints within the mc²56 MKII ’s routing
matrix can be controlled by external control systems such as VSM, Evertz, Quartz, BFE, Pharos and others. (If
your preferred supplier does not support the protocol, then please ask them to contact Lawo for further details):
Within your AdminHD configuration, each signal can be given a mapping address. Up to 16 different mapping
tables can be defined so that different control systems can be supported simultaneously.
Ø
To configure the mapping tables:
1. Double-click on the Core within the 'Core Browser' , and select the Map tab in the 'Parameter Box' :
2. For your chosen mapping table ( 01 to 16 ), enter the signal addresses which will be submitted to the
external control system:
·
unknown signal - submitted when an undefined source is connected to a defined destination.
·
no signal address - submitted when a signal is disconnected.
Please refer to your external control system’s documentation for details on which addresses to enter. Our
example shows the addresses for a Lawo zirkon control system.
3. Now select the first signal you wish to map to the controller, and select the Map tab.