LAWO mc256 MKII, Техническое руководство

Страница: 148 / 372

mc²56 MKII Technical Manual V5.10.2/1 148
Chapter 3: AdminHD
Core Configuration: Defining the System
Copy, Cut & Paste
If you are fitting several components of the same type, then you can use copy, cut and paste.
For example, you may be fitting several MIC cards to a DALLIS, or connecting several DALLIS (with the same I/O
configuration) to the Nova73. Or, you may need to move a DALLIS card from one slot position to another.
Note that all sub components and parameters are copied. Therefore, you may wish to configure the DALLIS or
card completely (including any
parameters ), before using copy, cut and paste.
Copy & Paste from the 'Hardware Panel'
1. Right-click on the source DALLIS card and select Copy :
The card is copied to AdminHD's clipboard; the address is shown in the status bar at the bottom of the display:
2. Then right-click on the destination card slot and select Paste :
The card, and all of its parameters, are pasted into the configuration.
3. Repeat step 2 to quickly assign the same card to a number of slots.
4. Select Cut (in step 1) to move a card to a different slot.
Note that Paste is only available if you select a valid destination. For example, if the DALLIS runs out of
audio channels, then you will not be able to select Paste .