Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 349 / 448

Malfunction, cause and remedy 23
Malfunctions on the single knotter 23.3
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 349
Malfunction:
There is no knot or a knot with very short ends that usually slip through the knot
loops.
BP000-290
Possible cause Remedy
Too much tension on the
closer of the billhook.
„
Increase the clamping effect on the billhook, refer to
page 232 .
The knotter hook ist worn.
„
Replace the billhook.
Not enough tension on twine
retainer. „ Adjust the twine retainer, refer to page 233 .
Malfunction:
The knot is stuck on the billhook.
Possible cause Remedy
Too much tension on the
closer of the billhook.
„
Increase the clamping effect on the billhook, refer to
page 232 .
Too much distance between
the scraper comb on the blade
lever and the back of the bill-
hook.
„
Align the blade lever with light hammer taps.
Rough surface of billhook.
„
Replace the billhook.
The setting of the twine
pusher is not correct.
„
Set the twine pusher, refer to page 226 . refer to page 227 .
Scraper distance of blade
lever too short.
INFORMATION: The blade
lever can be deformed by a
blunt twine blade.
„
Remove the blade lever and align it. Replace it, if
necessary. Check the cams on the knotter disc for wear and
replace the disc, if necessary.
„ Check the cams on the knotter disc for wear. Replace it, if
necessary.
The twine tension is too low. „ Apply the twine brake on the twine box by one or two turns,
refer to page 229 .
„
Increase the bale density. In automatic mode, increase the
target force of pressure, . In manual mode, increase the
target baling flap pressure,
refer to page 153 .
„
Increase the bale length. .