Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 298 / 448

22 Maintenance - Compressor
22.2 Checking oil level and changing oil at compressor
298
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
„
Remove the cover (4).
„
Remove the filter cartridge (5), knock out the dirt and blow it out from the inside to the
outside with an air jet.
ð
Replace the filter cartridge (5) in case it is excessively soiled or damaged.
„
Decompose and tap out the cover (4).
„
Install the filter cartridge (5).
„ Attach the cover (4) to the air filter (1) and secure it with retaining brackets (3).
„
Perform a visual inspection to check if the cover (5) is tightly closed with the air filter (1).
22.2 Checking oil level and changing oil at compressor
BP000-268
„ Observe the safety routine “Safely performing oil level check, oil change and filter element
change”,
refer to page 27 .
Checking oil level
„ Thoroughly clean the area around the oil dipstick (1).
„
Pull out the oil dipstick (1), clean it and insert it completely. Clean the oil dipstick with a lint-
free cloth.
„ Pull out the oil dipstick (1) and read off oil level.
ð
If the oil on the dipstick is below the Y marking:
„
Top up oil via drain plug (2).
„
Check oil level.
ð
If the oil on the dipstick is between the markings X and Y:
„ Insert the oil dipstick (1).
Changing oil
ü
A suitable container is available for escaping oil.
„ Pull out the oil dipstick (1).
„
Unscrew the drain plug (2) and drain the oil.
„ Screw in the drain plug (2) and tighten it firmly.
„
Top up new oil via oil filling hole (2).
„ Check the oil level by means of the oil dipstick (1).