Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 42 / 448

4 Machine description
4.2 Labelling
42
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
4.2 Labelling
INFORMATION
The entire identification plate represents a legal document and should not be altered or
rendered illegible!
BPG000-007
The machine data are specified on the type plate (1). The type plate is located on the right-hand
machine side below the twine box.
Information for enquiries and orders
If you have any further queries on the machine or if you want to order spare parts, always enter
type designation, vehicle identification number and year of manufacture of the corresponding
machine. To ensure that these data are always available, we recommend to enter them in the
fields on the front cover page of these operating instructions.
4.3 Baling process
ü
The terminal shows the working screen „manual mode“, refer to page 148 .
Starting with an empty bale channel
„
In manual mode, set the target baling flap pressure to 50 bar (in case of dry crops, e. g.
straw) and to 25 bar (in case of silage),
refer to page 153 .
„
Do not pick up the swath until the set target bale channel flap pressure is reached in the
terminal in order to produce a firm big bale.
„ Press two big bales in manual mode to fill the bale channel completely. In order to always
achieve the same solidity of bales automatically with materials of different properties (for
example with differing moisture content of materials on the same field), finally switch to
automatic mode,
refer to page 154 .
„
In automatic mode, the target baling force must be set to a level high enough so that the big
bale reaches the desired bale firmness. The contact pressure of the bale channel flaps in
the bale channel is controlled automatically by the job computer so that the pre-selected
baling force is reached. As the material becomes moister, it becomes more difficult to
compress the big bales. Thus, the baling flap pressure is reduced. If the material becomes
dryer, the baling flap pressure is increased. Thus, the pressure display may fluctuate
considerably. Bale quality and firmness remain at a constant level.