Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 256 / 448

16 Settings
16.26 Setting the cutting length
256
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
BP000-243
The auxiliary tool (1) is to be found on the left-hand side of the machine, near the blade
cassette.
Setting the cutting length via the blade group control system
In order to set different cutting lengths when the blade cassette is fully equipped, the upper and
lower blade group (2, 3) must be parallel to each other in different positions ( / ).
Depending on the blade group control system, the following cutting lengths can be set:
Cutting length Number of
blades Upper blade group Lower blade group
- No blades
88 mm 13 blades
88 mm 13 blades
44 mm 26 blades
Table cutting length depending on blade group control system (when fully equipped)
ü
The machine is shut down and safeguarded, refer to page 26 .
„
Attach the auxiliary tool (1) to the upper or lower blade group control system (2, 3).
WARNING! Risk of injury due to spring pressure on the auxiliary tool! Do not release the
auxiliary tool too early.
„ Turn the auxiliary tool (1) until the cams of the blade groups are either in position ( ) or in
position ( ).