Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 239 / 448

Settings 16
Setting the knotter fan 16.21
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 239
The areas of the blade lever that guide the twine (the marked area (I)) must be smoothed and
rounded to prevent the twine from tearing. The blade lever must be replaced when it is worn at
the marked area (formation of grooves).
ü
The machine is shut down and safeguarded, refer to page 26 .
„ Trigger the tying process manually with machine at standstill, refer to page 123 .
„
Turn the flywheel manually in working direction until the blade lever roll has reached the
highest point on the cam (4) in the knotter disc (5),
refer to page 124 .
„ Apply the flywheel brake, refer to page 100 .
„
Check dimension X.
ð
If the dimension is X=15–18 mm , the setting is correct.
ð If the dimension is not X=15–18 mm , the blade lever must be aligned.
„
Carry out a visual inspection to ensure that the marked area (I) is smoothed and rounded.
ð
If this area (I) shows wear (formation of grooves), the blade lever must be exchanged.
BP000-204
„ Carry out a visual inspection to ensure that twine ends are not unequally cut or frayed.
ð
If twine ends are unequally cut or frayed, regrind the twine blades.
ð
If twine blades are broken or show too much wear, exchange twine blades.
„ Repeat this process for all blade levers and twine blades.
16.21 Setting the knotter fan
BP000-209
The air flaps have been preset in the factory. A small hole next to the hole pattern (2) marks the
factory setting.
ü The machine is shut down and safeguarded, refer to page 26 .
„
In order to change the air flow in the air channel, manually lift the air guide plate (1) and
move on the hole pattern (2).