Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 255 / 448

Settings 16
Setting the flywheel brake 16.25
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 255
Turn the flywheel manually in working direction until the Variable Filling System (VFS) is in zero
position.
„
Apply flywheel brake refer to page 100 .
„
Measure and note down the dimension Y between the edge of the anvil (14) and the brake
plate (15).
„
Pull the sensing rake to the rear to initiate the Variable Filling System (VFS).
„ Turn the flywheel manually in working direction until the grooved ball bearing (7) is on the
highest position (area “I”) of the cam disc,
refer to page 253 .
„
Measure and note down the dimension Y between the edge of the anvil (14) and the brake
plate (15).
Æ
The dimension Y and the dimension Z must be identical.
Æ
If dimension Y and dimension Z do not have the same value, the brake yoke must be set.
Setting the brake yoke
„
Loosen the screw connection (20).
„ Move the brake yoke.
„
Tighten the screw connection (20).
„
Pre-tension the spring (21) of the brake to a dimension of X=55 mm (spring length only).
„
Recheck the absorbing unit again and repeat the procedure until the dimension Y and
dimension Z are identical.
16.25 Setting the flywheel brake
X
BPG000-075
The flywheel brake is mounted on the left-hand side of the flywheel. If the braking effect is no
longer sufficient when actuating the flywheel brake, it can be readjusted by extending the
spindle (1).
Factory setting Dimension X=186 mm
16.26 Setting the cutting length
The cutting length is set identically on both right and left machine side. The setting procedure on
the left side of the machine is described below. The same applies for the right side of the
machine.
The cutting length can be set in two ways:
• via blade group control system or
• via the number of inserted blades in the blade cassette.