Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 226 / 448

16 Settings
16.12 Checking/setting the twine pusher
226
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
Checking the overreach of the twine pushers at second knot
BP000-184
„
Turn the flywheel manually in working direction until the first knot (closing knot) is tied.
ð The twine pusher (1) swivels above the channel slot for the first time.
„
Turn the flywheel manually in working direction until the twine bar (1) swivels over the
channel slot for the second time.
„ As soon as the twine pusher (1) grabs the twine, apply the flywheel brake ( refer to
page 100 ) in order to block the knotter needles in this position.
„
Check the dimension X between the tip of the twine pusher and the twine.
Æ
If the dimension is X=5-10 mm , the setting is correct.
Æ
If the dimension is not X=5-10 mm , the twine pusher must be readjusted, refer to
page 224 .
„
Check the overreach on all twine pushers.
16.12 Checking/setting the twine pusher
For “single knotter” version
BP000-190
The twine pusher (1) pushes the twine away from the needle and pushes it against the knotter
hook. If the twine pusher does not grab the twine, the knotter hook cannot pick up the twine.
Then, the twine pusher must be set.