Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 224 / 448

16 Settings
16.10 Checking/setting the twine pusher
224
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
16.10 Checking/setting the twine pusher
BPG000-054
The twine pusher (3) pushes the twine away from the needle and pushes it against the knotter
hook. If the twine pusher (3) does not grab the twine, the knotter hook cannot pick up the twine.
Then, the twine pusher must be set.
Checking/setting the twine pusher relative to knotter needle (needle yoke)
ü
The twine pusher shaft is relieved, refer to page 228 .
Checking the twine bars
„
Trigger the tying process manually with machine at standstill, refer to page 123 .
„
Turn the flywheel manually in working direction until the lower needle (1) (needle yoke) is
just in front of the twine driver (2),
refer to page 124 .
„
Apply flywheel brake refer to page 100 .
„
Pull the linch pin and swivel up the knotter.
„ By turning the twine pusher, swivel the twine bar (3) to the middle of the knotter needle (1)
and check dimension X.
Æ If the dimension is X=2-4 mm , the setting is correct.
Æ
If the dimension is not X=2-4 mm , the twine pusher must be set.
„
Repeat this process for all twine pushers (1).
Setting the twine bars
„
Loosen the nut (4).
„ Move the twine pusher (3) until the dimension is X=2–4 mm .
„
Tighten the nuts (4).
„ Swing the knotter down and secure with the linch pin.
„
Repeat this process for all twine pushers (1).
„
Release flywheel brake, refer to page 100 .
„
Finish the tying process manually, refer to page 124 .
„
Apply flywheel brake refer to page 100 .
„ Tension the twine pusher shaft, refer to page 228 .
„
Check/set twine pusher relative to the channel slot, refer to page 225 .
„ Check the overreach of the twine pusher at second knot, refer to page 226 .