Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 227 / 448

Settings 16
Checking/setting the twine pusher relative to the channel slot 16.13
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 227
Checking twine pusher
ü
The twine pusher shaft is relieved, refer to page 228 .
„ Trigger the tying process manually with machine at standstill, refer to page 123 .
„
Turn the flywheel manually in working direction until the twine pushers (1) are centred above
the channel slot,
refer to page 124 .
„ Apply flywheel brake refer to page 100 .
„
Pull the linch pin and swivel up the knotter.
„
Check the dimension X between the tip of the twine pusher and the inside of the knotter
needle (2).
Æ
If the dimension is X=2-5 mm , the setting is correct.
Æ If the dimension is not X=2–5 mm , the twine pusher (1) must be readjusted.
„
Repeat this process for all twine pushers (1).
Setting the twine pusher
„
Loosen the screws (3).
„
Move the twine pusher (1) until the dimension is X=2–5 mm .
„ Tighten the screws (3).
„
Swing the knotter down and secure with the linch pin.
„ Repeat this process for all twine pushers (1).
„
Release flywheel brake, refer to page 100 .
„
Finish the tying process manually, refer to page 124 .
„
Apply flywheel brake refer to page 100 .
„
Tension the twine pusher shaft, refer to page 228 .
„ Check/set twine pusher relative to the channel slot, refer to page 227 .
16.13 Checking/setting the twine pusher relative to the channel slot
For “single knotter” version
BP000-191
„
Disconnect machine from tractor, refer to page 205 .
„ Apply flywheel brake refer to page 100 .
„
Check if the knotter gearboxes are in idle position, refer to page 124 .