Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 68 / 448

7 Initial operation
7.3 Drive train: Adjusting height
68
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
Adjusting the front parts of the drawbar
ü
During the adjustment process, the front parts of the drawbar (4) are supported by a
suitable tool.
„ Dismount the screws (3).
„
Move the front parts of the drawbar in the hole pattern until the height of the front parts of
the drawbar (2) correspond to the height of the tractor hitch.
„ Mount the screws (3).
Tightening torque, refer to page 262 .
Conversion from bottom to top hitching
The drawbar is mounted as standard as bottom hitch (I).
In order to convert the bottom hitching (I) to top hitching (II), both front parts of the drawbar (4)
are turned by 180 degrees.
„ Dismount the screws (3).
„
Remove the drawbar front parts (4).
„ Turn the drawbar front parts (4) by 180°, head them between the drawbar (7) and mount
them with screws (3) on the drawbar (7).
Tightening torque, refer to page 262 .
Conversion from top to bottom hitching
In order to convert the top hitching (II) to bottom hitching (I), both front parts of the drawbar (4)
are turned by 180 degrees.
„ Dismount the screws (3).
„
Remove the drawbar front parts (4).
„
Turn the drawbar front parts (4) by 180°, head them between the drawbar (7) and mount
them with screws (3) on the drawbar (7).
Tightening torque, refer to page 262 .
7.3 Drive train: Adjusting height
BPG000-024
The universally-jointed drive shaft between the intermediate bearing (1) and the tractor
transfuses the power of the tractor to the intermediate bearing. In order to have an ideal power
transmission, the articulation angle of the universally-jointed drive shaft must be as small as
possible in the range of the intermediate bearing.