Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 363 / 448

Before the beginning of the new season 25
Checking/venting friction clutch at flywheel 25.1
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 363
25 Before the beginning of the new season
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
„
To avoid accidents, the relevant safety instructions must be read and observed, refer to
page 14 .
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
„ The safety routines must be read and observed to avoid accidents, refer to page 26 .
Before the start of the new harvest season, inspect the machine thoroughly.
Keeping the machine in a perfect technical condition will significantly reduce costly running
problems during harvest time.
If this was not already done after the last harvest, the machine must be thoroughly cleaned
inside and outside.
„ Before placing the machine into service again, initiate the knotting process manually and run
through the large square baler manually. In doing so, check the functionality of the knotters
and the needles.
„ Clean the knotter from preservatives (vegetable oils).
„
Remove the grease from the drive disc and clean it.
„ Oil the chains.
„
Check the functionality of the knotter shaft brake (on the right of the knotter shaft).
„
Lubricate the machine completely according to the lubrication chart. Remove any
condensation water which may have collected in the bearings. Wipe away grease that
escapes from lubrication points.
„
Check the oil level in the gearboxes and top up the oil if required.
„ Check the hydraulic hoses and lines for leaks and replace them if necessary.
„
Check the air pressure of the tyres and top up the air if required.
„ Check all screws to make certain they are tight or retighten them if necessary.
„
Check all electrical connection cables and the lighting. Repair or replace if necessary.
„
Check the entire setting of the machine and correct if necessary.
25.1 Checking/venting friction clutch at flywheel
INFORMATION
Note
After longer periods of standstill, the linings of the friction clutch (2) may adhere to friction
surfaces.
„
Vent the friction clutch before use.