Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 348 / 448

23 Malfunction, cause and remedy
23.3 Malfunctions on the single knotter
348
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
Possible cause Remedy
Worn twine driver or twine re-
tainer
„
Replace worn twine driver or twine retainer.
The bale density is too high.
„
Reduce the baling pressure, refer to page 153 .
The twine tension is too high. „ Ease the twine brake on the twine box, refer to page 229 .
Malfunction:
Knots are too loose with two cleanly cut ends.
Possible cause Remedy
There is not enough tension
on the billhook.
„
Increase the clamping effect on the billhook, refer to
page 232 .
„
Replace the spring on the billhook.
Malfunction:
• The knot ends are frayed.
• The knot is only in the twine strand guided up by the knotter needle.
Possible cause Remedy
The twine blade is blunt.
„
Sharpen or replace blunt or jagged twine blade.
Not enough tension on twine
retainer. „
Adjust the twine retainer, refer to page 233 .
The bale density is too high. „ Reduce the baling pressure, refer to page 153 .
Worn twine driver or twine re-
tainer.
„
Replace worn twine driver or twine retainer.
Malfunction:
The knot is only in the twine strand which passes over the upper bale side.
BP000-289
Possible cause Remedy
Wrong positon of knotter
needle. „ Check/change position of knotter needle, refer to page 211 .
Wrong position of twine
pusher.
„
Adjust the position of the twine pusher, refer to page 226 ,
refer to page 227 .
Wrong swivel range of the
twine pusher.
„
Adjust the swivel range of the twine pusher, refer to
page 227 .
Broken or deformed retainer
springs.
„
Replace the retainer springs.
The twine tension is too high. „
Ease the twine brake on the twine box, refer to page 229 .