Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 242 / 448

16 Settings
16.22 Setting the plunger
242
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
16.22.3 Lateral setting of plunger
BP000-217
The plunger (1) must be centered in the bale channel (2).
Make sure that the plunger moves freely and does not scrub against the fixed scrapers in the
channel bottom and below the knotter table.
ü The machine is shut down and safeguarded, refer to page 26 .
„
Turn the flywheel in working direction ( refer to page 124 ) and move the plunger once
completely to the rear and front. In doing so, watch dimension X relative to the bale channel
(2).
Æ
If the dimesion measures X=1-2 mm at the narrowest point during the whole movement, the
setting is correct.
Æ If the dimesion measures X=1-2 mm at the narrowest point during the whole movement, the
plunger must be aligned.
Aligning the plunger
„
Turn the flywheel in working direction ( refer to page 124 ) and move the plunger (1) to the
frontmost positon.
„ Applying the flywheel brake, refer to page 100 .
„
Lifting twine boxes, refer to page 102 .
BP000-218
„
Remove the plate (3).
„
Loosen the slide discs (4).
If dimension X<1–2 mm
„
Put shims (5) between the plunger (1) and the slide discs (4).
„ Tighten the slide discs (4).