Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 315 / 448

Malfunction, cause and remedy 23
Malfunctions electrics/electronics 23.1
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 315
Possible cause Remedy
FMI 0: The upper limit value was greatly exceeded.
The baling flap pressure is too
high. „
Switch off the PTO shaft.
„
Check the pressure limiting valve for crop blockage.
„ Replace the pressure sensor.
522016-
Flywheel brake
Possible cause Remedy
FMI 7: The mechanics do not respond or the expected result was not achieved.
The flywheel brake is applied
when the KMC starts. „ Release the flywheel brake.
522017-
Bale chute
Possible cause Remedy
FMI 7: The mechanics do not respond or the expected result was not achieved.
In "road travel" mode the bale
chute is down.
„
Raise the bale chute.
522018-
Bale chute
Possible cause Remedy
FMI 7: The mechanics do not respond or the expected result was not achieved.
When the universal shaft is ro-
tating, the bale chute is up.
„
Lower the bale chute.
522019-
S5
Momentary switch "Raise bale chute"
Possible cause Remedy
FMI 2: The data is not permitted.
The momentary switch is
sticking. „ Eliminate the cause of the momentary switch sticking.
„
Replace the momentary switch.
522020-
S6
Momentary switch "Lower bale chute"
Possible cause Remedy
FMI 2: The data is not permitted.
The momentary switch is
sticking. „ Eliminate the cause of the momentary switch sticking.
„
Replace the momentary switch.
522021-
LR>MAX
Total baling force