Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 154 / 448

13 Terminal – Machine functions
13.23 Setting target baling force (automatic mode)
154
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
The bale channel flap pressure is entered by the user in manual mode. The pressure is built up
immediately if the PTO shaft is running and the machine is stopped. The pressure display
barely fluctuates on the display. To prevent damage to the machine, the bale channel flap
pressure is reduced to a non-critical value just before the system overloads. After several
seconds, the pressure set by the user is built up again. The bale channel flap pressure is
displayed in
bar or PSI depending on selected system of units.
20
4 cm
38 %
94 / 240 cm
2 / 4
1
2
EQG000-030
Value (1) and the bar display = actual bale channel flap pressure
Value (2) and the red mark on the bar display = set target bale channel flap pressure
Setting the target bale channel flap pressure
ü
Manual mode has been selected, refer to page 150 .
„
Change value, refer to page 162 .
13.23 Setting target baling force (automatic mode)
In Automatic mode, the pressure is automatically set based on the measured plunger force. The
pressure indication on the display may fluctuate considerably. The control functions only when
the packer is supplying forage to the piston. The baling force is displayed as a precentage.
20
4 cm
108 bar
94 / 240 cm
2 / 4
2
1
EQG000-031
Value (1) and the bar displays on right/left = actual baling force as %.
Value (2) and the red marks on the bar displays = target baling force as %.
Setting the target force of pressure
ü
Automatic mode has been selected, refer to page 149 .
„
Change value, refer to page 162 .