Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 99 / 448

Operation 9
Preparation for baling process 9.1
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 99
9 Operation
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
„
To avoid accidents, the relevant safety instructions must be read and observed, refer to
page 14 .
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
„ The safety routines must be read and observed to avoid accidents, refer to page 26 .
9.1 Preparation for baling process
Before starting baling process
ü
The correct cutting length is set, refer to page 255 .
ü The bale ejector is in front position (for “Comfort 1.0” version): refer to page 117 , for
“Comfort 1.0” version: refer to page 119 ).
ü
For "bale scale" version: The bale brake is locked, refer to page 57 .
ü
Twine reserves are sufficent.
ü The working height of the pick-up is set, refer to page 208 .
ü
The bale length is set correctly, refer to page 155 .
ü
The target baling flap pressure is set refer to page 154 .
ü The knotter shaft is unlocked refer to page 103 .
ü
The flywheel brake is released, refer to page 100 .
ü
For “self-steering axle” version and “Medium 1.0” version: The stop cock for the self-
steering axle is open, refer to page 204 .
„ Lower the bale chute into working position (for “Medium 1.0” version): refer to page 114 , for
“Comfort 1.0” version: refer to page 115 ).
„ Lower pick-up into working position, refer to page 111 .
Baling process
ü
The conditions in “Before baling process” are fulfilled.
„ Turn on the PTO shaft at minimum speed.
„
Slowly increase the PTO speed to 1000 rpm.
„ Wait until the pre-selected target bale channel flap pressure is reached in the terminal
before driving up into the swath for the first time,
refer to page 154 .