Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 241 / 448

Settings 16
Setting the plunger 16.22
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 241
Setting the eccentric roll
BPG000-043
„
Loosen the counter nut (4).
„ Loosen the clamping screw (3).
„
Raise or lower plunger via eccentric rolls until dimension is X=2-4 mm .
„ Make sure that all four rolls support equally.
„
Tighten the counter nut (4), tightening torque = 45 Nm.
„
Tighten the clamping screw (3), tightening torque = 160 Nm.
16.22.2 Checking/setting the cleaning rails
BP000-216
The cleaning rails (1) are positioned on the 4 rolls (3) of the plunger. They remove dirt deposits
from the running rails of the plunger.
ü
The machine is shut down and safeguarded, refer to page 26 .
„ Check dimension X.
ð If the dimension is X=1–2 mm , the setting is correct.
ð
If the dimension is not X=1–2 mm , the cleaning rails (1) must be adjusted.
Setting
„
Loosen the screws (3).
„
Adjust the cleaning rails (1) to dimension X=1–2 mm .
„
Tighten the screws (3).
„
Repeat this procedure for all cleaning rails.