Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 244 / 448

16 Settings
16.23 Setting packer relative to plunger
244
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
4 Packer coupling 11 Packer strip
5 Inspection window 12 Feeder strip
6 Main gearbox 13 Flywheel
7 Crank arm (I) Extended position (rear dead point)
The packer (10) is correctly set to the plunger (9) if the piston rod (8) is in extended position (I).
At the same time, the large roll on the packer strip (11), which runs in front of the feeder strip
(12), must be in the range
of 30–60 mm under the inspection window (5).
Adjusting packer relative to the plunger is only necessary if the following parts have been
disassembled:
• Packer coupling (4), packer gearbox (3), chain coupling (2)
• transfer gearbox (1) (or disassembling drive train transfer of transfer gearbox relative to
main gearbox (6))
• Crank arm (7) of main gearbox (6)
„
Check if the packer coupling is engaged, refer to page 244 .
„ Check if the Variable Filling System (VFS) is in zero position, refer to page 248 .
„
Move packer strip (11) into position, refer to page 245 .
„ Move plunger into position, refer to page 246 .
16.23.1 Checking packer coupling
Only for “open packer” version
BP000-222
ü
The machine is shut down and safeguarded, refer to page 26 .
The packer coupling is correctly engaged when the outer markings (2) on the packer coupling
correspond to the marking (1) on the cone of the packer coupling.