Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 232 / 448

16 Settings
16.19 Setting the single knotter
232
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en
If there are problems with the tying process during initial operation:
„ Do not adjust the parts immediately.
„
Check whether the parts are affected by paint damages, rust or rough spots.
Æ Deficiencies like paint damages, rust or rough spots must have to be rectified.
„
Check whether there is rust protection grease on the twine retainers and knotters.
ð
If there is rust protection grease, it must be eliminated from twine retainers and knotters.
16.19.1 Blocking/initiating function “tying process”
I
2 1
I
II II
2
BP000-107
In order to avoid unintentional triggering of the tying process during maintenance, adjustment
and repair work at the knotter, the lever for initiating the tying process must be locked.
ü
The machine is shut down and safeguarded, refer to page 26 .
Blocking function “tying process”
„
In order to block the function “tying process”, move the safety lever (2) from position (I) to
position (II) and set it down on the journal (1).
Initiating function “tying process”
„ In order to initiate the tying process, move the safety lever (2) from position (II) to position
(I).
16.19.2 Setting the clamping effect of the billhook
BP000-196
ü
The machine is shut down and safeguarded, refer to page 26 .
ü
The knotter shaft is secured refer to page 103 .