Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 229 / 448

Settings 16
Setting the knotter shaft brake 16.15
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 229
The twine pusher shaft (1) is tensioned or released by means of the spring (2).
ü The knotter gearbox is in idle position, refer to page 124 .
ü The flywheel brake is applied, refer to page 100 .
Tensioning the twine pusher shaft
„ In order to tension the spring (2), tighten the nut (3) until dimension X= 220 mm is measured
between the eyes of the spring.
Relieving the twine pusher shaft
„
In order to relieve the spring (2), unwind the nut (3) to the thread end of the eyelet bolt.
16.15 Setting the knotter shaft brake
BPG000-052
ü
The machine is shut down and safeguarded, refer to page 26 .
„
Pre-tension the springs (1) until the dimension is X=19 mm .
16.16 Setting the twine brake
BPG000-055
For “single knotter” version
The twine brakes (1) can be found in the twine boxes. The twine brakes (1) hold the lower
twines from the twine box to the lower twine brakes taut.
The drawing tension of the twine brake should only be set so high that the lower twines are taut
but still can be pulled easily.
Different types of twine may have different friction properties. Therefore, the drawing tension of
the twine strand must be checked when changing the type of twine.