Krone Big Pack 1270 XC, Оригинальная инструкция по эксплуатации

Страница: 27 / 448

Safety 2
Safety routines 2.4
BiG Pack 1270 XC
Original Operating Instructions 150000748_01_en 27
2.4.3 Safely performing oil level check, oil change and filter element change
WARNING
Safely performing oil level check, oil change and filter element change
If oil level check, oil change and filter element change are not performed safely, the
operational safety of the machine may be affected. This can lead to accidents.
Safely perform oil level check, oil change and filter element change.
In order to perform oil level check, oil change and filter element change safely:
„ Lower raised machine parts or secure them against falling, refer to page 26 .
„
Shut down and safeguard the machine, refer to page 26 .
„ Observe the intervals to check the oil, change it and to change the filter element, refer to
page 260 .
„
Only use oil qualities/oil quantities mentioned in the consumables table, refer to page 61 .
„ Clean the area around the parts (for example gearbox, high-pressure filter) and make sure
that foreign bodies do not get into the parts or the hydraulic system.
„
Check existing seal rings for damage and replace them, if necessary.
„ Collect leaking oil or waste oil in a special container and dispose of it properly, refer to
page 22 .
2.4.4 Running actuator test
WARNING
Run actuator test safely
When actuators are energised, functions are carried out directly and without a safety prompt.
This may cause the unintentional movement of machine parts, trapping and seriously or
fatally injuring persons.
ü Only persons familiar with the machine are permitted to perform the actuator test.
ü The person performing the test must know which machine parts are activated by
controlling the actuators.
„ Run the actuator test safely.
To run the actuator test safely:
„ Lower raised machine parts or secure them against falling, refer to page 26 .
„
Shut down and secure the machine, refer to page 26 .
„
Cordon off the danger zone of the actuated moving machine parts in a clearly visible
manner.
„
Ensure that there is nobody in the danger zone of the actuated moving machine parts.
„ Switch on the ignition.
„
The actuator test must only be performed from a safe position outside the area that is
affected by machine parts moved by the actuators.