Korg Electronic Keyboard, Руководство по параметрам

Страница: 137 / 1127

Program P8: Insert Effect 8–5: Insert FX
127
Note:
As with the meter as a whole, the number shown
in
FREE FOR VOICES
is only an approximation. For
example, if FREE FOR VOICES is showing 98, the
maximum polyphony for the HD-1 may not be exactly
172
× 0.98 (approximately 168).
The maximum polyphony will also depend on various
other parameters; for more information, see “A note
about polyphony” on page 32.
8–5b: IFX
Here you can choose the type of each insert effect 1
through 12, its on/off status, chaining, and adjust the
post-IFX mixer settings. For insert effects, the direct
sound (Dry) is always stereo-in and out. The
input/output configuration of the effect sound (Wet)
depends on the effect type. For more information,
please see “Insert Effects (IFX1…IFX12)” on page 734.
IFX1
IFX1 [000…185]
This selects the effect type for insert effect 1.
Category/IFX Select menu
When you press the popup button, the Category/IFX
Select menu will appear, letting you select effects by
category. Use the tabs to select a category, and then
select an effect within that category. Press the OK
button to execute your selection, or press the Cancel
button to cancel.
IFX1 On/Off [Off, On]
Switches the insert effect on/off.
If this is off, the input will simply be passed to the
output. (When 000:No Effect is selected, there’s no
difference between On and Off.)
The setting will alternate between on and off each time
you press the button.
Separately from this setting, you can use MIDI CC
#92 (on the global
MIDI Channel)
to turn all insert
effects off. A value of 0 turns them off, and values of
1–127 restore the original setting.
Chain to [IFX2…IFX12]
You can chain up to twelve insert effects together in
series, to create more complex effects. Set up the chain
using this parameter, and then enable it using the
Chain
check box, below.
Effects must be chained in ascending numeric order.
For example, IFX1 can be chained to any of IFX2
through IFX12, and IFX2 can be chained to IFX3
through IFX12.
You can chain two or more effects into the same down-
stream effect. For instance, both IFX1 and IFX2 can be
chained to IFX6.
Effects can also join a chain in the middle. For instance,
you can chain IFX3 to IFX4 to IFX9, and then chain
IFX2 to IFX9 as well.
The
Pan (CC#8)
,
Bus Select
,
REC Bus
, and
Send1
/
2
settings apply only to the last effect in the chain.
However, any effect in the chain can be sent to the FX
Control buses.
Chain [Off, On]
This enables the chain, as set up by the
Chain to
parameter, above.
Pan (CC#8) (Post IFX Pan) [L000…C064…R127]
Specifies the panning immediately after the insert
effect.
You can use CC#8 to control this.
Category/IFX Select menu