Juniper J4350, Руководство по началу работы

Страница: 105 / 284

Installing and Connecting a Services Router
5.
Install at least two mounting screws into each mounting bracket, in addition to
the center screws from which the router hangs (see Figure 32). Use a number
2 Phillips screwdriver to tighten the screws.
Figure 32: Completing the Installation
g003863
Connecting Interface Cables to a Services Router
You connect the interfaces installed in the Services Router to various network
media. For more information about the network interfaces supported on the router,
see the
J-series Services Router Basic LAN and WAN Access Configuration Guide .
1.
Have ready a length of the type of cable used by the interface, as specified in
“Network Cable Specifications and Connector Pinouts” on page 185.
2.
Insert the cable connector into the cable connector port on the interface
faceplate.
3.
Arrange the cable as follows to prevent it from dislodging or developing
stress points:
a.
Secure the cable so that it is not supporting its own weight as it hangs to
the floor.
b.
Place excess cable out of the way in a neatly coiled loop.
c.
Place fasteners on the loop to help maintain its shape.
Connecting Interface Cables to a Services Router
85