Juniper J4350, Руководство по началу работы

Страница: 180 / 284

J4350 and J6350 Services Router Getting Started Guide
6.
Insert the appliance coupler end of the replacement power cord into the
appliance inlet on the power supply faceplate.
7.
Insert the power cord plug into an AC power source receptacle.
NOTE: Each power supply must be connected to a dedicated AC power feed.
For information about connecting to AC power sources, see “Connecting Power”
on page 86.
8.
Verify that the power cord does not block access to Services Router
components or drape where people might trip on it.
9.
Press and release the power button to power on the router. Verify that the
POWER
LED lights steadily after you press the power button.
Removing an AC Power Supply from a J6350 Router
The power supplies are located at the right rear of the chassis. A
power supply weighs 2.4 lb (1.1 kg).
To remove an AC power supply from a J6350 Services Router (see Figure 47):
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about
ESD, see “Preventing Electrostatic Discharge Damage” on page 205.
2.
Press and release the power button to power off the Services Router. Wait for
the
POWER
LED to turn off.
NOTE: If the power supply is a redundant power supply in a J6350 Service Router,
you can leave the router powered on and power flowing in the alternate power
supply.
3.
Unplug the power cord from the power source receptacle.
4.
Unplug the power cord from the appliance inlet on the power supply faceplate.
5.
Slide the ejector tab on the power supply faceplate to the right and hold it in
place to unlock the power supply.
6.
Grasp the handle on the power supply faceplate, and pull firmly to start
removing the power supply. Slide it halfway out of the chassis (see Figure 47).
7.
Place one hand underneath the power supply to support it and slide it
completely out of the chassis.
160
Replacing Hardware Components