Hioki Power HiTester 3193, Инструкция по эксплуатации

Страница: 85 / 310

67
────────────────────────────────────────────────────
7.1 Overview
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
NOTE
Mode Display items
1P2W, DC +Ih, -Ih, Ih, +WP, -WP, WP, LF
1P2W Ih, +WP, -WP, WP, LF
1P3W, 3P3W
（When using channels 1, 2）
Ih1, Ih2, +WP12, -WP12, WP12, LF12
3V3A, 3P4W
（When using channels 1, 2, 3）
Ih1, Ih2, Ih3, +WP123, -WP123, WP123, LF123
Chapter 7
Integration Function
7.1 Overview
For a 1P2W system in DC mode, the integration function in this unit can
simultaneously integrate positive, negative, and total values for current (
I )
and active power ( P ) for all channels. There are six ways of controlling
integration by the various time settings, as listed below. All of these ways
can be combined with the floppy disk drive and printer.
Load factor (
LF ) calculation is also possible using the interval timer.
1. Manual integration
2. Interval integration
3. Timer control integration
4. Timer + interval integration
5. Real time integration
6. Real time + interval integration
･
Because of the internal circuit design, the maximum integration time is
10,000 hours, and the integration automatically stops if this time elapses.
･
Start, stop, and reset control of integration by either a panel operation or the
external control connector applies simultaneously to all items being
integrated. However, the GP-IB or RS-232C interface provides separate
control for each channel. For details see Chapter 12, "GP-IB and RS-232C
Interface."
･
The items which can be integrated depend on the connection mode and
coupling mode as shown in the following table.