Hioki Power HiTester 3193, Инструкция по эксплуатации

Страница: 137 / 310

119
────────────────────────────────────────────────────
12.3 Interface Outline
────────────────────────────────────────────────────
12.3.8 Output Queue
12.3.9 Input Buffer
12.3.10 Note on Commands Initiating Events
Response messages accumulate in the output queue and are read out as data
and cleared by the controller. The output queue is also cleared in the
following circumstances:
・
When a device clear is issued.
・
When the power is turned off and turned on again.
・
When the unit is reset by a key press.
・
When a query error is generated.
This unit has an output queue of 2000 bytes capacity. If the response
messages overflow this limit of 2000 bytes, a query error is generated, and
the output queue is cleared. Further, if a new message is received while the
output queue still contains data, the output queue is cleared, and a query
error is generated.
The 3193 has an input buffer of 2000 bytes capacity.
Messages which are received are put into this buffer and executed in order.
If the data accumulated in this buffer exceeds 2000 bytes the buffer becomes
full, and until a space again becomes available in the buffer the GP-IB
interface bus goes into the waiting state.
The following commands initiate events:
:HOLD
:PEAKhold
:INTEGrate:STARt
:INTEGrate:STOP
:INTEGrate:RESEt
When using these commands, either write each command on a separate line,
or follow it with a *WAI command.