Golden Dragon XML6125CLE, Руководство по ремонту

Страница: 87 / 613

德纳（北京）电机有限公司 Dana (Beijing) Electric Motor Co. Ltd
. 电话 Tel ： 010 － 69596333
北京市通州区宋庄 Songzhuang Tongzhou District Beijing 101118
德纳（北京）电机有限公司
Dana (Beijing) Electric Motor Co., Ltd.
9.2.3.3. Operation specifications for nameplates and related parts replacement:
1. Steps: see the diagram (Figure 4)
Step 1: Use needle-nose pliers to remove the rivet, and then remove the
nameplate (if the nameplate is directly attached to the motor with 3M glue, it
can be removed directly with a flat screwdriver).
Step 2: Install the new nameplate on the middle cover of the motor and use a
hammer to knock four new rivets into the rivet holes.
2.Tools for use:
Hammer, flat screwdriver, needle-nose pliers
Figure(4)
3. List of maintenance parts:
No.
Part number of
maintenance part
Name of maintenance
part
Quantity
per unit
Maintenance part replacement standard
4 —— Nameplate 1 Breakage and deformation
5 HW-1968 Rivet 4 Must be replaced after disassembly;
9.2.3.4. Operation specifications for signal cables and related parts replacement:
1. Steps: see the diagram (figure 5)
Step 1: Use a ratchet wrench and sleeve to remove the signal cable
fixing clip, and check whether it is damaged or deformed.
Step 2: Turn the lower edge of the protective cover of the signal
line interface up to reveal the signal line buckle, and then twist the
signal line joint to remove the signal line.
Step 3: Put the protective sleeve on new signal cable interface, then
screw the signal cable to the motor interface.
Step 4: Turn down the protective sleeve so that it completely
protects the interface.
Step 5: Use a fixed torque wrench to install the signal cable fixing
clip on the middle cover. The bolt tightening torque is 20 ± 2Nm.
2.Tools for use:
Fixed value torque wrench 0-10Nm, ratchet wrench, No. 13 sleeve,
Figure(5)
3. List of maintenance parts:
No. Part number Name of part Quantity Maintenance part replacement standard
6 HW-1742 Hex flange bolts 1 Damage to the thread or corrosion;
7 HW-3485 Signal line clip 1 Damage or deformation;
8 —— Signal line 1 Damage or poor communication;
9 FM-0011
Signal line interface
protective sleeve
1 Must be replaced after disassembly;
2-61