Golden Dragon XML6125CLE, Руководство по ремонту

Страница: 115 / 613

德纳（北京）电机有限公司 Dana (Beijing) Electric Motor Co. Ltd
. 电话 Tel ： 010 － 69596333
北京市通州区宋庄 Songzhuang Tongzhou District Beijing 101118
德纳（北京）电机有限公司
Dana (Beijing) Electric Motor Co., Ltd.
11.4. Maintenance items for high-voltage power cable (phase cable)
No.
Maintenance
content
Technical requirements Tool Operation specification
Maintenan
ce interval
1 Appearance
The wiring harness is complete,
the outer insulation layer has no
signs of cracking, damage and
cracking, and no signs of
discoloration caused by
overheating and overcurrent
Visual
inspection
Visually inspect the wiring harness for
intactness, signs of skin peeling, damage,
etc., especially no cracks at bends or
through the grooves
Every
5,000 KM
The air around the wiring
harness circulates and is easy to
dissipate heat. There should be
no spikes / sharp objects, dry,
dust-free
Visual
inspection,
brush and
vacuum cleaner
Visually inspect the high voltage wiring
harness for signs of discoloration caused
by overheating and overcurrent. If so,
contact a professional manufacturer for
technical judgment.
Every
5,000 KM
2 Installation
The bending radius of the wire
harness must be 8 times or more
the diameter (about 110mm) Visual
inspection and
tape measure Visually inspect and clean the surface with
a brush or vacuum cleaner to remove
surface ash, impurities and foreign matter
Every
5,000 KM
The wiring harness should be
tied firmly and not loose.
Vehicle wiring and fastening
must meet the design
requirements of the vehicle
manufacturer
Visual
inspection and
touching with
hands
Visual inspection and actual tape measure
to check if the bending radius of the wire
harness is 8 times or more the diameter
Every
5,000 KM
The wiring harness cannot be
bundled with low-voltage wiring
harness, gas, oil, water, etc.
Visual
inspection
Visually and manually check the binding
of the wiring harness. For example, check
whether the bandage is lost, the fixing
clips are loose, the fixing glue is detached,
and the thread protective cover is missing
Every
5,000 KM
Harness lugs are not loose and
secure
Torque wrench
and sleeve /
hexagonal
combination kit Visually check whether the wiring harness
is bundled with low-voltage wiring
harness, gas, oil, water, etc., unless there is
effective isolation between them
Every
2,000 KM
The harness lock is not loose
and fastened securely. Torque of
lock base: 25Nm; Torque of
lock cover: 12Nm
Lapp
—61610000
—61610013 Cooperate with corresponding tools,
review and tighten according to the
established torque requirements
Every
2,000 KM
Harness cover / screw / cover is
not loose and fastened
Torque wrench
and sleeve /
hexagonal
combination kit
Cooperate with corresponding tools,
review and tighten according to the
established torque requirements
Every
2,000 KM
2-89