Golden Dragon XML6125CLE, Руководство по ремонту

Страница: 6 / 613

General Instructions GI-3
2. General repair rules
 Fully and properly master the vehicle conditions, know about user requirements and keep a record of
relevant pre-operation and post-operation data.
 Observe the safety precautions mentioned in the Manual.
 Take necessary protective and preventive measures in order to avoid pollutions and damages to other
parts of the bus. Please clean the bus after operation.
 Provide a clean environment and observe the cleaning requirements mentioned in the Manual. Dirty
components may cause premature abrasions and unexpected troubles during repairs.
 Check and record necessary items and statuses according to the Manual.
 Replace all damaged or excessively worn-out components or assemblies.
 Always use original Golden Dragon components.
 Observe the assembly and disassembly regulations specified in the Manual to avoid damaging the
components.
Precautions for Towing
In case the bus is to be towed, please place the gearlever at the neutral position, fully release the parking
brake, eliminate any other potential risks to personal and bus safety, establish proper marks and strictly
observe relevant road safety laws and regulations.
 Ensure that the drive shaft of the vehicle under towing is disassembled. In case the differential or rear
axle shaft is in trouble, please remove both left and right rear axle shafts and seal the openings of the
wheel hubs to avoid losses of lubricating oils in the axles and ingress of dusts or foreign matters.
 Use heavy-duty cables to tow a vehicle. Fasten the cable securely to the hook of the frame.
 Connect the cable to the hook so that the angle between the towing direction and the traveling
direction of the vehicle under towing does not exceed 15 degrees both horizontally and vertically.
Avoid pulling the cable vehemently in case a hook is used to tow a vehicle. For instance, towing any
vehicle that sets in mire.
 Place the gearlever at the neutral position.
 Ensure that the starting switch is kept at the ‘ON’ position.
 Ensure that the engine of the vehicle under towing keeps running.
 If the engine is shut off, the brake system won't get any compressed air/vacuum. Such a situation is
very dangerous because the brake system can’t work if the engine is not running.
In addition, the power steering system won’t work either so that it would be hard to operate the
steering wheel, and
thus it is difficult to steer the vehicle.
It is noteworthy that the exhaust brake is disabled because the drive shaft has been removed.

Start up slowly to minimize possible vibrations. The towing speed shall be less than 30km/h.
 If the engine of the vehicle under towing is in trouble, the towing work shall be carried out by a
special-purpose towing truck.
1-5