Golden Dragon XML6125CLE, Руководство по ремонту

Страница: 338 / 613

R e p a i r M a n u a l
Corporate Division
Off-Road Driveline Technology
and Axle Systems
5871 214 102 6/7

Bolt brake to hub carrier.
Tightening torque (M16x1.5/10.9)
M
A
= 270 Nm
or (depending on the version)
Tightening torque (M18x1.5/10.9)
M
A
= 440 Nm
If there is a fit bolt, install it in front in driving direction.
Figure 23
Mount lining bracket (arrow 1) to the brake caliper. Mount bolt
(arrow 2) into the hole and secure it by means of spring cotter.
Figure 24
Mount suitable steel rod or similar to the vent slots on the brake
disk (see arrow) thus supporting the hub on the brake caliper and
blocking it against rotation.
Tighten hexagon screws on the flange shaft, if not yet tightened.
Tightening torque (M18x1.5/10.9)
M
A
= 440 Nm
Figure 25


Position brake cylinder on the brake caliper and fix it by means
of locknuts.
Tightening torque (M16x1.5)
M
A
= 195 ± 15 Nm
Observe installation position. See chapter 1/2 figure 7.
Use of new locknuts is imperative.
Bolt in emergency loosening screw at the brake cylinder.
Tightening torque
M
A
= 20 … 25 Nm
Figure 26
2
1
5-80