Endress+Hauser HART Proline Promass 83, Руководство по эксплуатации

Страница: 61 / 148

Proline Promass 83 Commissioning
Hauser 61
Recommended settings
"Pulsating Flow" Quick Setup menu
HOME-Position
→
F
→
MEASURED VARIABLE (A)
MEASURED VARIABLE
→
O
→
QUICK SETUP (B)
QUICK SETUP
→
N
→
QS PULS. FLOW (1003)
Function No. Function name Selection with (
P
)
1003 QS PULSATING FLOW YES
After
F
is pressed by way of confirmation, the
Quick Setup menu calls up all the subsequent
functions in succession.
▾
Basic configuration
2002 DISPLAY DAMPING 1 s
3002 TOTALIZER MODE (DAA) BALANCE (Totalizer 1)
3002 TOTALIZER MODE (DAB) BALANCE (Totalizer 2)
3002 TOTALIZER MODE (DAC) BALANCE (Totalizer 3)
Signal type for "CURRENT OUTPUT 1 to n"
4004 MEASURING MODE PULSATING FLOW
4005 TIME CONSTANT 1 s
Signal type for "FREQ./PULSE OUTPUT 1 to n" (for FREQUENCY operating mode)
4206 MEASURING MODE PULSATING FLOW
4208 TIME CONSTANT 0 s
Signal type for "FREQ./PULSE OUTPUT 1 to n" (for PULSE operating mode)
4225 MEASURING MODE PULSATING FLOW
Other settings
8005 ALARM DELAY 0 s
6400 ASSIGN LOW FLOW CUTOFF MASS FLOW
6402 ON-VALUE LOW FLOW CUTOFF Setting depends on diameter:
DN 1 = 0.02 [kg/h] or [l/h]
DN 2 = 0.10 [kg/h] or [l/h]
DN 4 = 0.45 [kg/h] or [l/h]
DN 8 = 2.0 [kg/h] or [l/h]
DN 15 = 6.5 [kg/h] or [l/h]
DN 15 FB = 18 [kg/h] resp. [l/h]
DN 25 = 18 [kg/h] resp. [l/h]
DN 25 FB = 45 [kg/h] resp. [l/h]
DN 40 = 45 [kg/h] resp. [l/h]
DN 40 FB = 70 [kg/h] resp. [l/h]
DN 50 = 70 [kg/h] resp. [l/h]
DN 50 FB = 180 [kg/h] resp. [l/h]
DN 80 = 180 [kg/h] or [l/h]
DN 100 = 350 [kg/h] or [l/h]
DN 150 = 650 [kg/h] or [l/h]
DN 250 = 1800 [kg/h] or [l/h]
DN 350 = 3250 [kg/h] or [l/h]
FB = Full bore versions of Promass I
6403 OFF-VALUE LOW FLOW CUTOFF 50%
6404 PRESSURE SHOCK SUPPRESSION 0 s
▾
Back to the HOME position:
→
Press and hold down Esc key
X
for longer than three seconds or
→
Repeatedly press and release Esc key
X
→
Exit the function matrix step by step