Elsner 70191, Инструкция по установке и эксплуатации

Страница: 97 / 133

96 Basic Setting WS1000
Control System KNX WS1000 Color • Status: 18.04.2016 • Errors excepted. Subject to technical changes.
Confirm with the OK button. The control system shows “Access code deleted”. Press

to go back to the menu. The control system no longer has an access code.
6.3.4. Using an SD card
The WS1000 Color control system has an SD card slot, which can be used to show
the images on the display and to store or transfer the set-up data to the control system.
The card is automatically recognised and the symbol „SD card“ appears in the bottom
right-hand corner of the display. Once the image data have been saved onto the card,
the symbol for "play-back" immediately appears in the weather data display. From here
you can start the slideshow directly.
To remove the card, briefly push down on the card. The card pops up slightly out of the
slot and can then be removed.
The SD card menu can be accessed by pressing the buttons:
Show images on display
The WS1000 Color can display digitally-stored image data as a slideshow or as individ-
ual images. For this, the image data must be saved onto an SD card and fulfil the fol-
lowing requirements:
• Data format Bitmap (BMP)
• Size 640 x 480 pixels
• Color intensity 24 bit or 16 bit
• No compression (RLE)
• The data must be saved in the uppermost level of the card's directory (root
directory)
The SD card slot can be found under
the covering flap. The SD card is
pushed into the slot, until it clicks into
place.
oder
WS1000
Settings
SD Card System