Elsner 70191, Инструкция по установке и эксплуатации

Страница: 74 / 133

73 Installation
Control System KNX WS1000 Color • Status: 18.04.2016 • Errors excepted. Subject to technical changes.
After connecting the cables screw the lower section of the housing (with the mounting
plate) onto the concealed box. Connect the flat ribbon cable to the display.
Put the lid cover on the upper section of the housing (frame with display). Put the upper
section of the housing onto the lower section of the housing from above and move it
downwards until the bottom edges are aligned. Screw on the upper section.
Structure of the connector board
4.2.2. Connect drives and devices
Drives and devices that should be controlled by the KNX WS1000 Color are connect-
ed via KNX or radio (Elsner RF Relay, RF-MSG) to the control system.
1 Connector for flat-ribbon cable to
front board
2 Weather station:
terminal 1 (GND) and 2 (+).
Supply voltage (e. g. indoor sensor
or camera):
terminal 3 (12 V) and 4 (0 V) or
5 (12 V) and 6 (0 V),
max. 400 mA altogether
3 Programming button KNX
4 KNX bus plug +/-
5 Microfuse T630 mA
6 Mains connection L/N/PE 230 V/
50 Hz
1
2
3
4
5
6
1
234
5
6