Elsner 70191, Инструкция по установке и эксплуатации

Страница: 89 / 133

88 Basic Setting WS1000
Control System KNX WS1000 Color • Status: 18.04.2016 • Errors excepted. Subject to technical changes.
The KNX actuators and sensors provided for communication with the WS1000 are dis-
played in the
KNX Settings menu and can be adjusted. Press the buttons:
A list of all KNX actuators and sensors set up for communication with the control sys-
tem (ETS) will be displayed. Press the button of the actuator or sensor that you wish to
set.
Different operational data and setting options will be displayed for the devices:
The KNX drives and devices appear in the menu for Automatic Setting .
6.2.5. Setting Camera Inputs
This menu point only appears if the control is equipped with a camera inter-
face!
Function Display of the block with number and type of input or
output
Name Press the button with the device's designation in order
to change the name. Enter the desired name via the
keypad that appears. Confirm your selection using
OK .

2.4. Input keyboard for names and codes
Status of KNX Block
(only for inputs)
Display of communication status
Correction factor
(for 2/4 byte floating point
inputs only)
Press the button in order to enter the correction factor
for the value received by the bus. Enter the factor via
the keypad that appears. Confirm your selection using
OK .
Measuring unit
(for 2/4 byte floating point
inputs only)
Press the button in order to input the measuring unit.
Enter the desired name via the keypad that appears.
Confirm your selection using
OK.

2.4. Input keyboard for names and code
Settings
(varies depending on type of
input/output)
Press Manual Direction in order to adjust the assign-
ment of the arrow keys (up/down, on/off). A selection
menu appears. Select whether the drive shall
retract
(or open) or extend (or close) when the button is
pushed. Confirm your selection using OK .
Press Manual Menu in order to set whether the drive/
sensor shall be displayed in the manual menu or not.
Confirm your selection using
OK.
Installation
Functional Blöcks
System
KNX Settings