Elsner 70191, Инструкция по установке и эксплуатации

Страница: 48 / 133

47 Automatic settings
Control System KNX WS1000 Color • Status: 18.04.2016 • Errors excepted. Subject to technical changes.
• Air humidity
• Air supply temperature (only for air supply devices)
• Exhaust air levels (only for roof ventilators WL610/WL305)
• Night-time re-cooling (together with indoor temperature for night-time re-
cooling)
• Timed ventilation (and levels for timed ventilation)
• Outdoor temperature (only for air supply devices)
• Recirculating air for heat recovery (only roof ventilators WL610/WL305)
• Recirculating air for condensation reduction (only for roof ventilators WL610/
WL305)
• Temperature for heating (only for fresh air/heating-combos on RF-VM)
• Enable/Disable automatic reset
As soon as a connected air conditioner is activated, ventilation is disabled, including
manually activated fans. The fans can be manually operated again immediately. The
delay time for the ventilation block can be adjusted.

System > Automatic Settings > General Settings > Ventilation Block

3.3. Adjust ventilation block
The automatic ventilation functions can be accessed by pressing the buttons:
Now you can select individual ventilators and adjust their settings. For each ventilator
the following settings can be changed:
Press the button to select the indoor sensor the control system will use for this venti-
lator (Pre-setting: first sensor in the list). As long as “
No Sensor ” is selected, the in-
door temperature and air humidity will not be taken into account by the control system
for this ventilator.
Confirm your setting with the OK button.
Press the button to set the indoor temperature above which the ventilation will be
switched on at night. Until an indoor sensor is selected, the indoor temperature will be
disregarded.
Setting the temperature: Adjust the value for the desired room temperature using the
arrow buttons. Pre-setting: 21.0 °C.
Roof Ventilator WS305/610, ventilation units at RF-VM module: The ventilator is
switched step by step, depending on the difference to the target temperature.
Automatic
Settings
Ventilation System
Sensor Selection
For all ventilation units.
Indoor Temp
For all ventilation units.
Temp. Ventilation