Elsner 70191, Инструкция по установке и эксплуатации

Страница: 47 / 133

46 Automatic settings
Control System KNX WS1000 Color • Status: 18.04.2016 • Errors excepted. Subject to technical changes.
Disable: If the window should be completely closed when there is rain, select No (de-
fault setting).
Confirm your setting with the OK button.
Please note that gap ventilation is not possible if the MSG Control has been activated
(signal duration set to permanent) in the basic settings of the window in the installation
menue.

6.1. Set up drives and drive groups
Press the button to set the movement position for the opening when a rain alarm trig-
gers. The function is only active if the gap ventilation is switched on.
With the arrow keys, specify the movement position in % (0% = closed, 100% = fully
open). Default setting: 5%.
Confirm your setting with the OK button.
Press the button to enable or disable the switchover to automatic mode at a set point
in time, or following a manual intervention.
The general Automatic Reset occurs daily at the same time.
Switching on: To set the window to Automatic at a set point in time, select Yes (this is
the default setting).
Switching off: To switch off the window’s Reset function, select
No .
Alternatively, the automatic function can be reactivated at a set time following a man-
ual intervention.
Switching on: To perform an Automatic Reset after a manual intervention, select Yes .
Switching off: To switch off the window’s Reset function, select No (this is the default
setting).
Confirm your setting with the OK button.
Automatic Reset time and/or period can be set.

System > Automatic Settings > General Settings > Automatic Reset

3.3. Define automatic reset
3.1.7. Automatic ventilation settings
For connected roof ventilation units and supply air units the following automatic set-
tings can be changed:
• Indoor sensor to be used for the ventilation unit
• Indoor temperature
Gap Position
Automatic Reset