Elsner 70191, Инструкция по установке и эксплуатации

Страница: 55 / 133

54 Automatic settings
Control System KNX WS1000 Color • Status: 18.04.2016 • Errors excepted. Subject to technical changes.
3.1.9. Automatic air-conditioner settings
For connected coolings/air conditioners the following automatic settings can be
changed:
• Indoor sensor to be used for the air-conditioner
• Indoor day temperature
• Night mode (period) and indoor night temperature
• Enable/Disable automatic reset
As soon as a cooling/air-conditioning unit is activated, windows will be closed and
ventilators switched off. The delay time applicable to this can be set.

System > Automatic Settings > General Settings > Ventilation Block

3.3. Adjust ventilation block
The automatic climate control functions can be accessed by pressing the buttons:
Now you can select individual air conditioners and adjust their settings. For each air
conditioner the following settings can be changed:
Press the button to select the indoor sensor the control system will use for this cooling
unit (Pre-setting: first sensor in the list). For as long as “
No sensor ” is selected, the
indoor sensor will not be taken into account for control of the cooling unit, i.e. no au-
tomatic control will take place.
Confirm your setting with the OK button.
Press the button to set the indoor temperature above which the cooling unit will be
switched on during the day. Until an indoor sensor is selected, the automatic cooling
is deactivated. Use the arrow buttons to change the value according to your wish. De-
fault setting: 30.0°C
Confirm your setting with the OK button.
The cooling will engage as soon as the temperature exceeds the set value and is shut
down again when the temperature is more than 2°C below the set value (hysteresis).
Automatic
Settings
Air conditioner System
Sensor Selection
Indoor Temp. Day