DTM Print CX86e, Руководство пользователя

Страница: 122 / 214

122
—
"ORDER BELT UNIT" is not displayed when [ADMIN SETUP] > [PANEL SETUP] > [NEARLIFE STATUS] is set to [DISABLE]
on the operation panel.
—
Use extra care when handling the image drum (the glossy cylinder), because it is fragile.
—
Do not expose the image drum unit to direct sunlight or strong light (approximately 1,500 lux or more). Do not
leave the image drum unit exposed for 5 minutes or more, even under room lighting.
—
You can change the timing for displaying the "ORDER BELT UNIT" message. Set it using [ADMIN SETUP] > [OTHERS
SETUP] > [NEARLIFE SETUP] > [BELT NEARLIFE] on the operation panel. Available values are from 500 to 5,000 (in
500 increments).
Insert your finger into the recess on the top of the machine and pull up the lever.
—
Open the top cover until it stops.
Burns may result.
The fuser unit is extremely hot. Do not touch it.
—
Hold the blue handle and pull out the image drum unit vertically.
—
Pull it out after opening the top cover fully.
—
Place the image drum unit you took out on a flat surface and cover it with black paper, etc. so that the image
drums are not exposed to light.
—
Hold the handle (black) of the transfer belt unit and pull it out vertically.
Burns may result.
The fuser unit is extremely hot. Do not touch it.