DTM Print CX86e, Руководство пользователя

Страница: 149 / 214

149
Message Description
REPLACE TONER
412:TONER EMPTY
The toner has run out. Replace the toner cartridge with a new one.
TONER NOT RECOMMENDED
556:ERROR
Replace the toner cartridge with a recommended one.
INSTALL TONER
[ERRCODE]:TONER MISSING
A toner cartridge is not installed in the machine. Set the toner car-
tridge in the machine.
IMAGE DRUM NOT RECOMMENDED
692, 702, 706, 686:ERROR
Replace the image drum unit with a recommended one.
UNKNOWN CONSUMABLEGO TO USER MANUAL "TROU-
BLE SHOOTING"
709
You can use any consumables in your product, but you must accept
the risks of using non-genuine consumables.
If the use of non-genuine consumables causes damage to the prod-
uct or results in your product not functioning to its full specification,
then such damage or effect on the product is not covered by warran-
ty.
To accept these risks and to restore function;
(1)Turn off your product.
(2)Press and hold the «CANCEL» button and turn your product on.
(3)After start up, release the «CANCEL» button.
Note: This operation will be recorded for future reference.
OPEN TOP COVER
[ERRCODE]:PAPER SIZE ERROR
Paper of an inappropriate size has been fed. Check whether the
loaded paper size is correct or whether multiple sheets of paper have
been fed. Then open and close the top cover.
CHECK FEEDER
390:PAPER JAM
A paper jam occurred while supplying paper. Remove the paper jam.
Or the cut type setting and paper sensor position of the machine do
not match. Change the position of the top sensor and bottom sensor
so that they do not overlap if their positions were matching. Change
the position of the top sensor and bottom sensor so that they match
if they were not overlapping.
OPEN TOP COVER
[ERRCODE]:PAPER JAM
A paper jam occurred while feeding paper. Remove the paper jam.
ERRCODE 380 : Feed
ERRCODE 381 : Transport
ERRCODE 382 : Exit
ERRCODE 389 : Printing Page Lost
CHECK CUTTER UNIT
730-02:ERROR
An error has occurred in the cutter unit. Check the cutter unit.
MARK NOT FOUND
730-06:ERROR
The paper mark could not be found. Check the position of the paper
sensor.
If an error occurs even if the sensor position is aligned, calibrate it.
Adjusting the Paper Sensors (Sensor Calibration)
REPLACE IMAGE DRUM
[ERRCODE]:IMAGE DRUM LIFE
The image drum unit has reached the end of its lifetime. Replace the
image drum unit with a new one.
REPLACE FUSER UNIT
[ERRCODE]:FUSER UNIT LIFE
The fuser unit has reached the end of its lifetime. Replace the fuser
unit with a new one.
REPLACE BELT UNIT
[ERRCODE]:BELT UNIT LIFE
The transfer belt unit has reached the end of its lifetime. Replace the
transfer belt unit with a new one.